AGES 5+
WARNING:
20251
CHOKING HAZARD-Small parts.
Not for children under 3 years.
LITE BRITE product!
Batteries included. Replace
with 4 x 1.5V “C” or LR14 size
alkaline batteries. Phillips/cross
head screwdriver (not included)
needed to replace batteries.
Includes paint spinner,
4 bottles of paint and
7 design cards
Note that paint may stain
some surfaces. Wash with
soap and warm water.
3. You can drip two paints at once
to create a whole new effect.
Remember, you can use your
imagination to make all kinds of
cool designs!
OTHER IDEAS
Here are a few extra play features and
suggestions:
1. Put paint on your design card before
you place it on the spinner platform.
Try making a smiley face, a favorite
symbol or any design you wish!
2. Once the paint has dried on your
design card, you can stand the FLASH
ART Neon Paint Spinner upright and
put it on display in your room!
3. You can also frame or hang your dry
design cards.
4. Check out our FLASH ART Neon Paint
Spinner refill sets to create other cool designs.
Available at your local LITE BRITE retailer!
CLEANING UP
Turn off the FLASH ART Neon Paint Spinner and wipe with a
damp paper towel to clean and prevent paint build-up.
TROUBLESHOOTING
If your FLASH ART Neon Paint Spinner shuts off automatically
after 6 seconds, press either the
or
buttons while
the spinner is on. You will need to repeat this step each time
you replace the batteries.
TO REPLACE BATTERIES
Use a Phillips/cross head screwdriver to
loosen screw in battery compartment door
(screw remains attached to door). Insert
4 fresh 1.5V “C” or LR14 size alkaline
batteries. Fit door back into place and
tighten screw.
CAUTION: TO AVOID BATTERY
LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers’ instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert
them correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away
from other electrical equipment. Reset (switching off and back on again or removing and
re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always
remove from the product before recharging. Recharge batteries under adult supervision.
DO NOT RECHARGE OTHER TYPES OF BATTERIES.
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Consult the dealer or an experienced radio/TV technician for help.
© 2005 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
U.S. Patent Pending
20251
P/N 6453540100
|