F145-1189
Replacement Door for Classic White Digital
Thermostats
WHITE-RODGERS
INSTALLATION INSTRUCTIONS
Before installing the new door onto your digital thermo-
stat, you will need to attach one of the two operating
instruction labels to the new door.
HOLD
COPY
1. Determine the type of thermostat you have. If the two
buttons on the far right of the thermostat look like
fig.1, you will use the label numbered 153-7090.
RUN
PRGM
If the two buttons on the far right of your thermostat
look like fig.2, you will use the label numbered 153-
7075.
Figure 1
2. Placethethermostatdooronatableandpositionitso
that the recessed area is facing up, and the door is
positioned as shown in fig. 3.
HOLD
TEMP
3. Peel the backing off the label you will use. Working
from the upper edge, lay the label in place on the
door. Gently wipe the label down to remove any air
bubbles.
ADV
PRGM
4. To install the door, insert the extruded dimples into
therecesseslocatedonthelowerrightandleftedges
of the thermostat (it may be necessary to bend the
door slightly to fit it into place).
Figure 2
Recess
Extruded
Dimple
Figure 3. Install door
WHITE-RODGERS DIVISION
EMERSON ELECTRIC CO.
9797 REAVIS ROAD
PART NO. 37-5161A
Printed in U.S.A.
9241
ST. LOUIS, MISSOURI 63123-5398
R
|